- Model# ALL1000RM
- Brand: Aladdin Light Lift
- Height: 9"
- Width / Diameter: 18"
- Depth: 27.5" long
- Lamping: 110V (Bulb NOT included)
- Most chandelier comes with a 1/4 IPS fixture coupler included. If an (European) chandelier was supplied with a 1/8 IPS, 3/8 IPS, or 1/2 IPS screw collar loop or threaded stem, please contact Arcadian Lighting!
- Canopy height of the chandelier needs to be at least 1.75" deep to house the IPS Fixture Coupler.
- Directional pulleys can be used to change winch cable direction, up or down, between motor assembly and chandelier pulley assembly. No lateral cable direction change is allowed.
- Order the remote light lift with conduit cut to minimum if the depth for the bracket and pulley on top is less than 12.5"
- Dimmer switch for the chandelier lights need to be wire on a separate circuit from the motor.
- To determine the minimum length of winch cable necessary for installation, take measurement from the motor assembly, through the directional pulleys, to the chandelier pulley assembly, and down to the floor.
- For sloped ceiling up to 32.5 degree, please order the optional sloped ceiling adapter, which includes a threaded nipple, brass ball, and canopy.
- Both Keyswitch and SmartLift Controller come with 50 ft wire.
This Aladdin Light Lift remote mount chandelier light lift can accommodate chandeliers up to 1,000 pounds. This design features your choice of two pulley assemblies and a flat or sloped ceiling adapter.
The Aladdin Light Lift is a motorized lift system for your chandelier.
Aladdin light lift's patented system has been rigorously tested and uses the latest technology for electrical components and its gearing mechanism. each model is equipped with independent locking systems to securely hold the chandelier.Features:
- 1000 lbs. maximum lifting capacity
- 65 ft. Standard winch cable length: 90 ft.and 120 ft. (optional)
- The remote mount light lift may be mounted on an angle, vertically, horizontally or upside down, if secured properly
- Chandelier pulley assembly must be mounted horizontally leveled and directly above where chandelier will hang.
- Remote mount light lift motor assembly can be mounted up to 25 ft. from the pulley directly above the chandelier - romex and limit switch wiring.
- 110V motor and light voltage requirements
- Dimension: 18" wide x 27.5" long x 9" high
- Mounted on two 38" channel struts
- SmartLift Controller included - Can be programmed to automatically stop at any desired height above the floor.
- Wattage Capacity: 2200 watts standard - 1 circuit
Optional 3300 watts - 2 circuit is available
Questions and Answers
- There are no questions for this item, yet.
- There are no reviews for this item, yet.